7m 6" Flexible Multifuel Flue Liner Pack/kit for logburner Wood Burner Multi Fuel Stove Chimney

Description

7m 6" Flexible Multifuel Flue Liner Pack/kit For Stove In this kit you are getting 7m of flexible flue liner and a complete accessory pack of 1 x 6" Top Plate, 1 x 6" Top Clamp, 1 x 6" Nose Cone, 1 x 6" Protection/Inset Sleeve, 1 x 6"to 5" Adapter to flue pipe & 1 x Chimney Notice Plate this kit enables the install of a 6" Multi Fuel flexible liner into a masonry chimney where the chimney pot is to be removed or replaced. 150mm/6" Top Plate: A steel closure plate with a central hole just slightly larger than the outer diameter of the flexible chimney liner. This plate sits on the top of the stack and when used with the Top Clamp provides the support required for the flexible liner. 150mm/6" Top Clamp: The Top Clamp is used at the top of the stack in conjunction with a Top Plate to support the flue below 150mm/6" Nose Cone: The nose cone is attached to the end of the liner and provides protection to the end of the liner during installation 150mm/6" Protection/Insert Sleeve: The Protection Sleeve slides inside the flexible chimney liner at the top of the installation and is used together with the Top Plate and Top Clamp. It provides rigid internal support for the top clamp when clamping the liner. it also helps to protect the top of the liner during sweeping 150mm/6" Adaptor to Flue Pipe: Used to connect the flexible chimney liner to single wall pipe at the base of the flue. The hole on the inside of the adaptor allows any moisture and deposits to run into the inside of the pipe instead of escaping down the outside of the pipe. Connects 5" single wall pipe to 6" flexible flue liner. Chimney Notice Plate: Chimney Notice plate is now a Building Regulations requirement. They must be filled out and fixed near to the appliance or within a meter cupboard. all of these components are made from very high quality stainless steel and therefore have a very long lifespan