Tesla Wheel Decal (Carbon Fiber)

Everyone is right, it is difficult to put on exactly right. If you stand back a few feet,you won't notice its slightly off.. Take your time,don't rush it. Once its on and your satisfied, go to Ace or home depot and buy a spray can of Rust Oleum 2X Ultra cover CLEAR gloss or satin.Make sure that the surface of the cap is clean and spray 2 very light coats on the cap. This will water proof the decal...Good luck!!

Very accurately die cut vinyl and looks great on my Tesla Model 3 19" wheels. Here are two application tips:(1) My center covers are black with a silver Tesla emblem. The smallest mis-orientation of these vinyl decals shows a small sliver of silver (say that 3x times fast!). I just took a small black Sharpie pen and colored black the outer perimeter of the silver emblem. Now they look great - red on black and any slightest mis-orientation is not visible at all.(2) 2 of the 4 vinyl cuts had the Tesla T "eyebrow" mis-registered to the Tesla "T" on the transfer plastic. Its noticeable as the gap distance between the T and the eyebrow is not a constant gap distance over the arc on the transfer plastic. Simply cut the clear plastic transfer film into two pieces and apply the T and eyebrow separately on each hub.

These look fantastic!!! Just peel them off and stick them to the wheel. I forgot to clean the wheel with alcohol first, to remove grease, break dust, wax, etc., but they did stick very well and really stand out nicely. After a couple washes, they are holding up very well. Highly recommend!!!!

A very non-intrusive way to improve the looks of your Tesla.The transfer tape doesn't really help me much. I ended up just peeling it off and eyeball it myself. Picked the red one and it looks really nice. I recommend these for any Tesla owner.

It is almost Imposible to align it if you just paste it directly on the wheel. You should peel the insignia sticker itself to the center of the wheel

Looks great, not that easy to get exactly to cover the design on the wheel but even offset a mm or 2 it looks very good.

The installation is kinda simple, but aggravating to line them up perfectly. Just takes a little longer than you would like sitting on the garage floor to install them. Looks great and I love how they accent the car.

Looks great on my car. A little hard to apply. I suggest removing the cap that the stickers go on from you rims to make installation easier.